Compression limiters in bolted joint applications

>Compression limiters are used to protect plastic components in bolted joints and maintain a threaded fastener's clamp load by eliminating plastic creep. To function properly, the bearing surface beneath the bolt's head must extend over the compression limiter to contact the plastic component. If this bearing surface is too small, the host component may not be retained by the bolt resulting in a poor joint.

>There are several methods to ensure sufficient bearing surface under the bolt's head. These include the use of a flanged bolt, washer, or headed compression limiter. The individual component cost, ease or complexity of assembly, and overall cost of each configuration influence which method is best suited for each application.

>Ideally, compression limiter length is equal to or slightly less than the host thickness. The amount of material compressed under the bolt's head varies depending on the application's loading and plastic properties. This area of compression must be large enough to withstand forces attempting to pull the assembly apart, yet small enough to allow sufficient plastic compression so that the compression limiter contacts both the bolt and the mating component.

>Several factors including speed and assembly method must be considered when determining the most cost effective solution for a specific application. Typical figures for different fastener combinations, manually assembled, highlight the approximate differences in efficiency:

>* Flanged bolt, symm-etrical compression limiter; 1.24 seconds average speed

>* Bolt, headed compression limiter; 1.44 seconds average speed

>* Washer, bolt, symmetrical compression limiter; 2.48 seconds average speed.

>In these tests conducted by Spirol, we an see that assembly with a flanged bolt was the fastest, followed by that with a headed compression limiter, which must be oriented. As expected, the addition of a third component (the washer) significantly slowed the assembly process, requiring twice the assembly time.

>When an assembly is automated, it is imperative to ensure the design is as efficient as possible. The addition of a third component, such as a washer, may not be desirable when automating due to feeding and alignment challenges. Other common factors affecting efficiency include number of components and ease of orientation. All bolts, headed compression limiters, and some washers require orientation. Due to their relatively low head to outer diameter ratio and short length, headed compression limiters and washers are more difficult to mechanically orient than bolts. Conversely, symmetrical compression limiters do not need to be oriented.

>An assembly with a flanged bolt only requires one component's orientation while that with a headed compression limiter or washer requires two components be oriented. There are, of course, some design intangibles. Use of a headed compression limiter or flanged bolt in serviceable assemblies may be preferable as there would be no washer that could be accidentally omitted during reassembly. These are also preferable in applications where there are multiple assembly locations and/or poor quality control.

>When looking at individual component costs, generally, fasteners are the least expensive components in an assembly. Relative cost differences between bolts and compression limiters vary depending on component supplier and bolt characteristics. Of the three potential combinations discussed, the method with a washer, bolt, and non-headed compression limiter provides the lowest component cost for controlling bearing surface. However, as previously stated, the cost of the fastening components is often the least significant compared to the overall cost of the assembly.

>In conclusion, we can see that the best method to ensure adequate bearing surface on the plastic in a bolted assembly depends on an application's requirements and limitations. A washer may be preferred in lower volume and/or non-serviced applications. In higher volume, automated, and/or serviceable applications, a non-headed compression limiter with a flanged bolt is the easiest to assemble and provides the lowest total cost. Both configurations with a washer or flanged bolt will provide a lower cost solution than using a headed compression limiter.